Colorcon™ Setup - Chauvet COLORdash Batten User Manual

COLORcon™ Setup
Single Row
Application
SET UP DOWN EXIT
Repeat Row Block Application
ID Address: 01 ID Address: 02
ID Address: 01 ID Address: 02
ID Address: 01 ID Address: 02
The figure above shows 9 fixtures connected in
series. Three rows comprised of 3 fixtures are
addressed identically. Each fixture has {ID ON} in
the fixture's settings. You must set the {Range}
settings in the controller to [003] before accessing
{Effect} programs.
COLORdash™ Batten User Manual
1. FIXTURE CONTROL PANEL SETUP
Activate ID addressing in each fixture by setting panel function {ID ON/OFF} to ON.
{MENU}  {Settings)  {ID ON/OFF}  [ON]
Set ID addresses in each fixture by setting panel function {ID address} to
incremental values. (I.e. 1,2,3,4,5,6,etc...)
{MENU}  {Settings}  {ID address}  [01 ~ 66]
It is not necessary to set the DMX address.
2. CONTROLLER SETUP
When using the {Effect program} function, it is necessary to set the {Settings} 
{Range} setting, which is the quantity of fixtures in series.
{MENU}  {Settings}  {Range}  [ (No. of fixtures) ]
ID Address: 01
ID Address: 02
The figure above shows 6 fixtures connected in series with corresponding addresses.
Each fixture has {ID ON} in the fixture's settings. You must set the {Range} settings
in the controller to [006] before accessing {Effect} programs.
ID Address: 03
ID Address: 03
ID Address: 03
SET UP DOWN EXIT
15
ID Address: 03 ID Address: 04
Block Application
ID Address: 01 ID Address: 02
ID Address: 04 ID Address: 05
ID Address: 07 ID Address: 08
The figure above shows 9 fixtures
connected in series with corresponding
addresses. Each fixture has {ID ON} in
the fixture's settings. You must set the
{Range} settings in the controller to
[009] before accessing {Effect}
programs.
ID Address: 05
ID Address: 06
ID Address: 03
ID Address: 06
ID Address: 09
SET UP DOWN EXIT
9/5/2008 9:49 AM