Table of Contents
Advertisement
Lens Assembly Installation/Replacement
The COLORdash™ Batten comes with 15 lens assembly pre-installed from the factory. However, there is 1 other
optional lens kit (CL20X30) available as accessories, which will alter the beam angle. These each come in
packages of 20pcs each. Therefore, if you have a fixture that has more than 20 LEDs (such as the COLORdash™
Batten), then be sure to take this into account. Please follow the below instructions for proper
replacement/installation.
LED PCB
3. Lens holder Screws
1.
2.
1.
2.
3.
4.
Warning!
COLORdash™ Batten User Manual
Remove the side, plastic UV cover (black) by removing the screws that hold it in place. There
are 4 screws to remove for this step.
Slide the LED plastic cover out through the side of the plastic black cover that was removed.
After removing the side cover, remove the screws that hold the lens assembly in place. There
are 8 screws for this step.
Note: use care when performing this procedure, as this gives you direct access to
the LEDs, which are very fragile.
You now should have full access to the lens assembly. This must be removed and the old
lenses must be replaced with the new lenses. The same assembly is to be reinstalled with the
new lenses in place and the process is complete.
When replacing the lens assembly, please make sure that the power is
disconnected from the fixture beforehand.
2. LED plastic UV cover
11
1. Plastic Side Cover
4. LENS Assembly
9/5/2008 9:49 AM
Advertisement
Table of Contents
