Power Connector - HP EliteBook 9470m Maintenance And Service Manual

2. Lift the touchpad from the computer (2).
3.
Remove the touchpad.
Reverse this procedure to install the touchpad.
NOTE: When replacing the touchpad, make sure to install the screws into holes closer to the edge of
computer.

Power connector

Description
Power connector
Before removing the power connector, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive cover (see
b. Hard drive (see
c. Service cover (see
66 Chapter 4 Removal and replacement procedures
Battery on page 41), and then remove the following components:
Hard drive cover on page
Hard drive/SSD drive on page
Service cover on page
47)
48)
53)
Spare part number
702875-001