106
108
109
KD Workshop Manual_cod. ED0053029350_1° ed_ rev. 00
106
Mechanical speed governor
The governor (with centrifugal weights) is housed inside the crankca-
se and is controlled by a camshaft gear.
To remove speed governor 1 remove camshaft bell 2 and speed go-
vernor control gear 3.
Mechanical speed governor components (standard)
1 Drive rod
2 Stop ring
3 Bearing
4 Washer
5 Pin
6 Weights
7 Weight support
8 Shaft
Mechanical speed governor operation (standard)
Weights 1 are moved to the periphery by the centrifugal force and
thus axially shift the washer 2 and the drive rod 3 which, by means of
a linkage, move injection pump control lever 4.
The governor springs 5 placed under tension by the accelerator con-
trol lever 6 offset the weights 1 centrifugal force.
Balance between the two forces keeps speed at an almost constant
level in spite of load variations.
Disassembly / Reassembly
9 Key
10 Thrust washer
11 Bearings
12 Shaft support
13 Gear
14 Spring washer
15 Flat washer
16 Nut
4
- 47 -