15
16
17
18
KD Workshop Manual_cod. ED0053029350_1° ed_ rev. 00
Crankshaft pulley
Remove the pulley using extractor serial no. 1460.200.
Components:
1 Left-handed bolt
2 Washer
3 Blower control pulley
Note: It is only possible to check crankshaft axial clearance after
tightening the pulley.
Blower control pulley diameter
There are three pulleys with different diameters A which take account
of engine settings:
A = 142 mm
( from 2401 to 3000 r.p.m. )
A
= 147 mm
( from 2001 to 2400 r.p.m. )
1
A
= 163 mm
( from 1500 to 1800 r.p.m. )
2
Check S surface in contact with oil seal ring and, if necessary, rub
with a fine grain emery cloth.
Timing cover
Loosen the screws and remove the cover.
When refitting tighten screws at 25 Nm.
Check oil seal ring 1 and replace if warped, hardened or worn-out.
Replace gasket 2.
Disassembly / Reassembly
4
- 27 -