172
173
174
KD Workshop Manual_cod. ED0053029350_1° ed_ rev. 00
PROCEDURES TO BE CARRIED OUT BEFORE START THE ENGINE
- Remove all protections and coverings.
- Remove the rust preventer from the external part of the engine by
means of adequate products (solvent or degreaser).
- Tension the blower timing belt.
- Disassemble the injectors and introduce, by means of a bowl, motor
oil on the piston crown ( no more than 2 cc for every cylinder).
- Remove valve covers and spray motor oil on the valves, then turn the
crankshaft manually for a few revolutions.
- Start the engine and heat it for about 10 minutes.
- Remove the drain plug and let the protective oil flow completely.
- Reinsert the drain plug.
- Carry out motor oil refilling to the upper level of the rod using the oil
recommended by the manufacturer for a normal engine operation.
13
Storage
- 101 -