Transmitting Stored Dtmf Codes; Selecting A Transmit Speed; Selecting A Pause Duration; Dtmf Key Lock - Kenwood TM-D710E Instruction Manual

■ Transmitting Stored DTMF Codes

1 Press and hold the microphone [PTT].
2 While transmitting, press the Tuning control.
• The last called DTMF Memory channel name and
number appear on the display. If no name has been
saved for the channel, the DTMF code appears.
3 While still transmitting, rotate the Tuning control to
select your desired DTMF Memory channel, then
press the Tuning control to set the channel.
• Additionally, you can press a DTMF key
corresponding to your desired channel ([0] ~ [9]) to
select the channel and begin transmission.
• The stored DTMF code scrolls across the display and
is transmitted.
• The code will be transmitted even if you release [PTT]
before the entire code has scrolled across the display.
• If no DTMF code is stored in the selected channel, the
frequency display is restored.

■ Selecting a Transmit Speed

Some repeaters may not respond correctly if a DTMF
code is transmitted at fast speed. If this happens,
change the DTMF code transmission speed from FAST
(default) to SLOW.
1 Enter Menu mode and access Menu 302.
2 Set the speed to FAST or SLOW.

■ Selecting a Pause Duration

You can change the pause duration stored in DTMF
Memory channels; the default is 500 msec.
1 Enter Menu mode and access Menu 303.
2 Select a speed (in msec) from the available list: 100/
250/ 500/ 750/ 1000/ 1500/ 2000.

DTMF KEY LOCK

This function will lock the DTMF transmission keys so that
they will not transmit if they are accidentally pressed. To
lock the DTMF keys, turn this function ON.
1 Enter Menu mode and access Menu 304.
2 Set the key lock to ON or OFF.
DTMF-2