Kenwood TM-D710E Instruction Manual page 39

Command Name Short
NPATH NPATH
NTSGRP NTSGRP
NTSMRK NTSMRK
NTSMSG NTSMSG
OVERKILL OVE
PACLEN P
PACTIME PACT
PERSIST PE
PPERSIST PP
RAMTEST RAMTEST Checks the RAM after clearing it.
READ R
RESET RESET
RESPTIME RES
RESTART RESTART
RETRY RE
ROUTE ROU
SENDPAC SE
SLOTTIME SL
SPATH SPATH
STREAMCA STREAMC
STREAMDB STREAMD
STREAMSW STR
TOUT TOUT
TRACE TRAC
TRANS
Specifies digipeater callsigns to be added when the
UISSID parameter in a received packet is 8 or 12.
Specifies a group code to be used for making a
$PNTS sentence.
Specifies a mark number to be used for making a
$PNTS sentence.
Specifies a message to be used for making a $PNTS
sentence.
Specifies the number of old messages to be deleted
when the TNC mailbox does not accept a new
message because the memory is full.
Specifies the maximum length of the data portion of a
packet.
If set to EVERY, sends a packet at intervals of the
specified period (n). If set to AFTER, sends a packet
only once after the specified period (n). The unit of n
is 100 milliseconds.
Specifies a parameter to calculate probability for the
PERSIST/SLOTTIME method.
Causes the TNC to use the PERSIST/SLOTTIME
method when ON, or the DWAIT method when OFF.
Specifies one or more message numbers to be read
from the TNC mailbox.
Restores the default status for all the commands.
Specifies the acknowledgment packet transmission
delay. The unit of the parameter is 100 milliseconds.
Causes the TNC to function as if it is switched OFF
then ON.
Specifies the number of transmission retries.
When ON and receiving a packet forwarded by a
PBBS, leaves the included route information.
Specifies a character which forces a packet to be sent.
Specifies the period of random number generation
intervals for the PERSIST/SLOTTIME method. The
unit of the parameter is 10 milliseconds.
Specifies digipeater callsigns to be added when the
UISSID parameter in a received packet is 9 or 13.
When ON and multiple connections take place,
receiving a packet causes the TNC to display the
callsign.
When ON, causes the TNC to display a stream switch
character included in a received packet.
Specifies a character to be used for switching streams.
Specifies the time-out time of the TNC mailbox. When
no packet is received within the specified time, a
disconnect takes place. The unit of the parameter is
10 seconds.
When ON, causes the TNC to display all received
packets in their entirety.
Causes the TNC to exit Command mode and enter
T Transparent mode. To restore Command mode, press
and hold [Ctrl], then press [C] three times.
Description
PACKET-6
Parameter Default
Call1, ... call7
0 ~ 3 characters
$00 ~ $14 $00
0 ~ 20 characters
0 ~ 255
0 ~ 255 128
EVERY/ AFTER n
AFTER 10
(n = 0 ~ 250)
0 ~ 255 128
ON/ OFF
−
−
−
0 ~ 250
−
0 ~ 15
ON/ OFF
0 ~ $7F $0D
0 ~ 250
Call1, ... call7
ON/ OFF
ON/ OFF OFF
0 ~ $7F $01
0 ~ 250
ON/ OFF OFF
−
−
−
−
0
ON
−
−
−
5
−
10
ON
3
−
ON
30
−