Restoring Factory Default Settings - ATEN CS1708A User Manual

CS1708 / CS1716
A A

Restoring Factory Default Settings

You can restore the factory default settings (listed on the next page) for the
CS1708 / CS1716
A
accounts are removed from the system. All port names and setting are also
removed.
Note: A jumper cap is required when performing this procedure.
1. Unplug the CS1708
2. Remove the cover of the CS1708
3. Place a jumper cap over pins 1-2 of the J17 jumper on the mainboard.
4. Plug in the CS1708
appear on the KVM console screen:
USERNAME AND PASSWORD INFORMATION AND PORT/USER
INFORMATION HAS BEEN CLEARED. PLEASE POWER OFF THE
SWITCH, REMOVE THE JUMPER, CLOSE THE CASE, THEN
RESTART.
5. Unplug the power adapter again.
6. Remove the jumper cap from pins 1-2 of the J17 jumper.
7. Replace the cover on the KVM switch.
8. Plug in the CS1708
9. You should now use the default username and password to log in to the
CS1708 / CS1716
A
62
User Manual
. With this procedure, the administrator and all user
A
/ CS1716 power adapter.
A A
A
/ CS1716 power adapter. The following directions
A A
/ CS1716 power adapter.
A A
.
A
/ CS1716 .
A
J17