Single Level Installation - ATEN CS1708A User Manual

CS1708 / CS1716
A A

Single Level Installation

In a single level installation, there are no additional switches daisy chained
down from the first unit. To set up a single level installation do the following:
1. Ground the CS1708
off to all the computers you will be connecting up.
2. Using the console cable provided, connect a keyboard, mouse, and
monitor to the CS1708
Connection Diagrams on the following page.
3. Use KVM cable sets (as described in the Cables section on page 3), to
connect any available KVM port to the keyboard, video and mouse ports
of the computer you are installing. Refer to the KVM Cable Installation
Diagrams on the following page.
4. Plug the power adapter cable into the CS1708
then plug the power adapter into an AC power source.
5. Turn on the power to the computers.
Single Level Installation Diagram
1 2
4
Note: The numbers in the diagram correspond to the numbered steps above.
14
User Manual
/ CS1716 and make sure that power has been turned
A A
/ CS1716
A
5
3
console port. Refer to the Cable
A
/ CS1716
A
power jack,
A