Powering Off And Restarting; Usb Peripheral Devices - ATEN CS1708A User Manual

Powering Off and Restarting

If it becomes necessary to power off a CS1708
before restarting it:
1. Shut down all the computers that are attached to the CS1708
Note: Unplug the power cords of any computers that have the Keyboard
Power On function. Otherwise, the CS1708
receive power from the computers.
2. Unplug the CS1708
3. Wait 10 seconds, then plug the CS1708
4. After the CS1708
power on the computers.
Note: If you have shut down more than one station, power up the highest
station first and work your way down to the lowest one.

USB Peripheral Devices

The front panel USB port is available to connect a USB peripheral device (flash
drive, CD-ROM drive, printer, etc.) to the CS1708
connected to the CS1708
at-a-time basis. The peripheral device is available to computers connected to
the CS1708 / CS1716
A
computers connected to daisy chained switches.
The USB peripheral device is automatically detected on target computers when
switching ports on the CS1708
a computer connected to port 1 to a computer connected to port 2, the
peripheral device automatically disconnects from the computer on port 1 and
connects to the computer on port 2.
/ CS1716 from its power source.
A A
/ CS1716 has started and ascertained its station ID,
A A
/ CS1716 can access the USB peripheral on a one-
A A
on the same level only, and is not available to
A
/ CS1716
A
Chapter 3. Basic Operation
/ CS1716
A A
/ CS1716
A
/ CS1716 back in.
A A
/ CS1716
A
. For example, when switching from
A
, do the following
/ CS1716 .
A A
will still
A
. Any computer
A
21