Restoring Original Factory Default Settings
A method is provided to restore the original factory default settings and the
original password for the default Super Administrator account. All other Super
Administrators, Administrators, Users, and groups are deleted. The station
name, Webpage Session Timeout setting, network settings, and date and time
are retained. The procedure requires a jumper cap.
1. Power off the KM0832 and remove the top cover of the switch module.
2. Locate the J3 jumper. Slide a jumper cap over pins 1 and 2.
3. Power on the switch. Follow the directions on the console screen (as
displayed below):
USERNAME AND PASSWORD INFORMATION AND PORT/USER
INFORMATION HAS BEEN CLEARED. PLEASE POWER OFF THE
SWITCH, REMOVE THE JUMPER, CLOSE THE CASE, THEN
RESTART.
4. After you start back up, you can login to the KM0832 Administrator
Utility and OSD exactly as you did the first time the switch was run. To
log in to the KM0832 Administrator Utility see page 29. To log in to the
OSD see page 75.
J3
J8
Appendix
111