Scsi Bus Operation - Sony SDX-1100V/R User Manual

5.2. SCSI Bus Operation

5.2.1. Typical SCSI Operation
This example describes the typical SCSI bus sequence between the host and the drive.
After waiting for the bus clear time the Host arbitrates for the SCSI bus. It does this by asserting BSY and
1.
the data line corresponding to its bus ID. If any other devices wish to compete for the bus, they also assert
BSY and the appropriate data line. Each arbitrating device then inspects the data bus. The device with the
highest ID wins the bus. All the other devices must release BSY and their data lines.
The Host attempts to select the target by asserting SEL and releasing BSY. The Host maintains its ID and
2.
asserts the target's ID on the data bus. Each target then checks the data lines. If the target's ID matches that
on the data bus, it accepts selection by asserting BSY. Once the Host has detected BSY being asserted, it
asserts ATN to indicate that it wants the target to go to the MESSAGE OUT phase. The Host releases SEL.
The target now has control of the SCSI bus and it is the target which switches between phases. The target
3.
responds to the ATTENTION condition and initiates the MESSAGE OUT phase. The Host sends an
IDENTIFY message which tells the target which logical unit the Host wishes to talk to. The fact that the
target responds to the ATN indicates to the Host that the target can accommodate more than just a
COMMAND COMPLETE message.
The target initiates the COMMAND phase and transfers the Command Descriptor Block from the Host. In the
4.
COMMAND phase, the target decodes the command and either executes the command (TEST UNIT
READY) or sets itself up for a data transfer to the Host (READ, WRITE, and INQUIRY etc.). The target then
either switches to the STATUS phase, if the command is completed, or if it is ready to transfer data, the
DATA phase.
The data transfer length is set by the Host in the Command Descriptor Block. The target will remain in the
5.
DATA phase until all the data is transferred.
The target then initiates a STATUS phase and transfers one byte to the Host to indicate whether the target
6.
has successfully completed the command. If the target has detected an error, the next command that the
Host is expected to send is REQUEST SENSE. This allows the target to return further status information to
the Host.
The target completes the SCSI sequence by going to the MESSAGE IN phase and transferring a
7.
COMMAND COMPLETE message to the Host. The target then releases BSY allowing the bus to go to the
BUS FREE state.
5.2.2. Disconnect
In order to improve bus usage and performance, the unit is capable of temporarily disconnecting from the bus,
consequently allowing other initiator-target communications to take place. To do so, however, the Host needs to
support Disconnect/ Re-select. The mechanism for performing the Disconnect/ Re-select procedure is
implemented as follows:
The Host arbitrates for the SCSI bus and upon winning the bus it proceeds to select target device. Prior to
1.
releasing SEL and completing the selection phase, the Host asserts the ATN line. The Host then releases
SEL and BSY to allow the target to assume control of the SCSI bus. By asserting ATN, the host indicates
that the target should go to a MESSAGE OUT phase.
At this point, the target responds to the Host ATTENTION condition by initiating a MESSAGE OUT phase
2.
and receiving a message from the Host which tells it whether or not the Host allows Disconnects for the
desired logical unit on the target.
If the Host does not send an Identify message, the target assumes that Disconnects are not permitted.
3.
SONY AIT-5 drive SDX-1100V series Ver.1.0
5.SCSI Interface
5-3