Attaching And Removing The Dust Cover; Attaching The Dust Cover - Sony SDX-1100V/R User Manual

3.Installation

3.1.7. Attaching and Removing the Dust Cover

3.1.7.1. Attaching the Dust Cover

(1) Align the dust cover's hinge clips (one on each side) with the pins of the drive bezel.
• The dust cover should be positioned so that the six magnets on the cover's back face the drive bezel.
• Holding the dust cover at an angle as shown in the figure below, set the hinge clips on top of the bezel
pins, positioning them so that they bracket the pins.
(2) Press down at an angle on each side in turn until you hear the hinge clips click into place.
Caution:
Do not press the dust cover in horizontally from the side. Doing so could cause the dust cover to break.
(3) Close the dust cover.
This completes attachment of the dust cover.
3-6 SONY AIT-5 drive SDX-1100V series Ver.1.0