Table of Contents
Advertisement
6.Command Specification
6.31. WRITE BUFFER 3Bh
Bit
7
Byte
0
1
2
3
(MSB)
5
6
(MSB)
8
9
The WRITE BUFFER command is used in conjunction with the READ BUFFER command as a diagnostic
function.
The WRITE BUFFER command except Echo buffer is executed only when there is no tape inserted in the drive or
when the tape is positioned at BOT. Otherwise, the drive will return a CHECK CONDITION status with an ILLEGAL
Request Sense Key.
Note: The drive will write any buffered data to tape prior to executing the WRITE BUFFER command except Echo
buffer. Any data that is then transferred by the WRITE BUFFER is not written to tape.
Mode: The drive supports the following values within the Mode field. If any other value is set, the drive will
terminate the command with a CHECK CONDITION status with an ILLEGAL REQUEST sense key.
Combined Header and Data Mode (0000b) - In this mode, the test data to be transferred must be preceded by a
four-byte header. The four-byte header consists of all reserved bytes. The Parameters List Length specifies the
maximum number of bytes that will be transferred during the DATA-OUT phase. This number includes four bytes
of header, so the data length to be stored in the buffer is transfer length minus four. The initiator will ensure that
the transfer length is not greater than four plus the available length that is returned in the header of the READ
BUFFER command.
Data Mode (0010b)- In this mode, the DATA-OUT phase contains only buffer test data.
Echo Buffer (1010b) - In this mode the data will be stored in an echo buffer. Data will be sent aligned on four-byte
boundaries. The BUFFER ID and BUFFER OFFSET fields are ignored in this mode. The drive assigns echo
buffer on a per initiator basis. The initiator will attempt to ensure that the parameter list length does not exceed the
capacity of the echo buffer. The BUFFER CAPACITY field in the READ BUFFER echo buffer descriptor
determines the capacity of the echo buffer. If the PARAMETER LIST LENGTH field exceeds the buffer capacity,
the drive will return a CHECK CONDITION status with a Request Sense Key of ILLEGAL REQUEST.
Buffer ID: The supported values are:
Buffer ID
0
80
81
82
83
If an unsupported Buffer ID code is requested, the drive returns a CHECK CONDITION status with an ILLEGAL
REQUEST sense key.
6-106
6
5
4
Operation Code (3Bh)
Reserved
Buffer Offset
Parameter List Length
Table 6-104: WRITE BUFFER Mode Field
Mode
0000b
Combined header and data
0010b
Data
1010b
Echo Buffer
Table 6-105: WRITE BUFFER Mode Field
Description
Write Group Buffer
Write Group Buffer
Write Group Buffer
Write Group Buffer
Write Group Buffer
3
2
Mode
Buffer ID
Control
Description
Offset
0
- 0x01000000
0
- 0x01000000
0x01000000 - 0x02000000
0x02000000 - 0x03000000
0x03000000 - 0x03700000
SONY AIT-5 drive SDX-1100V series Ver.1.0
WRITE BUFFER
1
0
(LSB)
(LSB)
Advertisement
Table of Contents
