Table of Contents
Advertisement
LOG SENSE
Code
Flag
12h
Tape
Directory
Corrupted
on Load
13h
Nearing Media
Life
14h
Clean Now
15h
Clean Periodic
16h
Expired
Cleaning
Media
17h
Invalid
Cleaning Tape
18h
Retention
Requested
19h
Dual-Port
Interface Error
1Ah
Cooling Fan
Failure
1Bh
Power Supply
1Ch
Power
Consumption
1Dh
Drive
Maintenance
SONY AIT-5 drive SDX-1100V series Ver.1.0
Flag Type
Recommended application client message
W
The directory on the tape cartridge has been
corrupted.
File search performance will be degraded. The
tape directory can be rebuilt by reading all the data
on the cartridge
I
The tape cartridge is nearing the end of its
calculated life. It is recommended that you:
1. Use another tape cartridge for your next backup.
2. Store this tape cartridge in a safe place in case
you need to restore data from it.
C
The tape drive needs cleaning:
1. If the operation has stopped, eject the tape and
clean the drive
2. If the operation has not stopped, wait for it to
finish and then clean the drive.
Check the tape drive user's manual for device
specific cleaning instructions.
W
The tape drive is due for routine cleaning:
1. Wait for the current operation to finish.
2. Then use a cleaning cartridge.
Check the tape drive user's manual for device
specific cleaning instructions.
C
The last cleaning cartridge used in the tape drive
has worn out:
1. Discard the worn out cleaning cartridge.
2. Wait for the current operation to finish.
3. Then use a new cleaning cartridge.
C
The last cleaning cartridge used in the tape drive
was an invalid type:
1. Do not use this cleaning cartridge in this drive.
2. Wait for the current operation to finish.
3. Then use a valid cleaning cartridge.
W
The tape drive has requested a retention operation
W
A redundant interface port on the tape drive has
failed
W
A tape drive cooling fan has failed.
W
A redundant power supply has failed inside the
tape drive enclosure. Check the enclosure user's
manual for instructions on replacing the failed
power supply.
W
The tape drive power consumption is outside the
specified range
W
Preventive maintenance of the tape drive is
required.
Check the tape drive user's manual for device
specific preventive maintenance tasks or call the
tape drive supplier helpline.
6.Command Specification
Probably cause
Tape drive powered down
with tape loaded, or
permanent error
prevented the tape
directory being updated
Media may have
exceeded its specified
number of passes
The drive thinks it has a
head clog, or needs
cleaning
The drive is ready for a
periodic clean
The cleaning tape has
expired
Invalid cleaning tape type
used
The drive is having
severe trouble reading or
writing, which will be
resolved by a retention
cycle
Failure of one interface
port in a dual-port
configuration, e.g. Fibre
channel
Fan failure inside tape
drive mechanism or tape
drive enclosure
Redundant PSU failure
inside the tape drive
enclosure or rack
subsystem
Power consumption of the
tape drive is outside
specified range
The drive requires
preventative maintenance
(not cleaning).
6-21
Advertisement
Table of Contents
