Report Density Support 44H - Sony SDX-1100V/R User Manual

REPORT DENSITY SUPPORT

6.19. REPORT DENSITY SUPPORT 44h

Bit 7
Byte
0
1
2
3
4
5
6
7 (MSB)
8
9
The REPORT DENSITY SUPPORT command provides information regarding the supported densities for the
logical unit be sent to application client.
MEDIA : The MEDIA bit of ZERO indicates that the drive will return density support data block for densities
supported by the logical unit for any supported media. The data returned by the drive will be static if the MEDIA
bit is ZERO. The MEDIA bit of ONE indicates that the drive will return density support data block for densities
supported by the mounted medium. If the MEDIA bit is ONE and the logical unit is not in the ready state, a CHECK
CONDITION status will be returned. The sense key will be set to NOT READY.
The Allocation Length field specifies the maximum number of bytes that the drive may return.
The REPORT DENSITY SUPPORT command returns the REPORT DENSITY SUPPORT header followed by one
DENSITY SUPPORT data block. The Density support data blocks will be in numerical ascending order of the
primary density code value for each block.
Bit 7
Byte
0 (MSB)
1
2
3
Available Density Support Length: This field specified the number of bytes in the following data that is available
to be transferred. The Available density support length does not include itself.
SONY AIT-5 drive SDX-1100V series Ver.1.0
6 5 4
Operation Code (44h)
Reserved
Allocation Length
Table 6-83: REPORT DENSITY SUPPORT header
6 5 4
Available Density Support Length
Reserved (00h)
Reserved (00h)
3 2
Reserved
Reserved
Reserved
Reserved
Reserved
Control
3 2
6.Command Specification
1 0
MEDIA
(LSB)
1 0
(LSB)
6-79