Table of Contents
Advertisement
LOG SENSE
6.6.3. Summary List of Supported Pages (00h)
The summary list of supported log pages returns the list of page codes supported by the target. This page is only
valid for the Log Sense command and if sent to the initiator during a Log Select command will cause termination
with a CHECK CONDITION status with sense key set to ILLEGAL REQUEST and ASC of INVALID FIELD IN
PARAMETER LIST.
Bit
7
Byte
0
Reserved
1
2
(MSB)
3
4
17
This page returns the summary list of supported log pages for the specified logical unit to the requesting initiator.
IMPLEMENTORS NOTE: Typically, an initiator will first request page ZERO to determine the list of pages
supported by the device. The page code parameters are a list containing the page codes of the supported pages
for the logical unit in ascending order. Note that neither Threshold nor Cumulative values have any meaning for
this page.
6.6.4. Write and Read Error Counters Pages (02h or 03h)
The Error Counters Pages (Write and Read) are used to report statistical information about Write and Read soft
and hard errors and retries. Each parameter is a counter which is updated by the target every time the
corresponding event occurs. The format of the Error Counters Pages is given below:
Bit
7
Byte
0
Reserved
1
2
(MSB)
3
Bit
7
Byte
0
(MSB)
1
2
DU (0)
3
4
(MSB)
7
The Page Code is one of the following:
SONY AIT-5 drive SDX-1100V series Ver.1.0
Table 6-13: Supported Log Pages
6
5
Page Length (00 0Eh)
Supported Page List
(00 02 03 07 2E 30 31 33 34 35 39 3C 3D 3Eh)
Table 6-14: Write/Read Error counters page
6
5
Table 6-15: Error Counter Descriptors
6
5
Parameter Code
DS (1)
TSD (0)
ETC (0)
Parameter Length (n-3)
Parameter Value
Table 6-16: Page Code
Page Code
02h
Write error Counter Page
03h
Read error Counter Page
4
3
2
Page Code (00h)
Reserved (00h)
4
3
2
Page Code (02h or 03h)
Reserved
Page Length (n)
4
3
2
TMC (00)
Description
6.Command Specification
1
0
(LSB)
1
0
(LSB)
1
0
(LSB)
LBIN (0)
LP (0)
(LSB)
6-17
Advertisement
Table of Contents
