Table of Contents
Advertisement
CLASS 1
LASER PRODUCT
32
INFORMATION
General information on laser devices
This device is a CLASS 1 LASER PRODUCT. This means that the laser is designed in such a way as to
ensure that the maximum permissible emission value cannot be exceeded under any circumstances.
Caution:
If operating devices or methods other than those specified here are employed, it may lead to
dangerous exposure to emissions.
This device emits laser radiation. Because of the danger of eye injuries, the unit may only be opened
or serviced by trained personnel.
If settings other than those stated here are used or other procedures are carried out, this may lead to
dangerous exposure to radiation.
Troubleshooting
Not every kind of sound interference is caused by a defect in your hi-fi system. Cables that have
accidentally been disconnected, damaged CDs and flat batteries for the remote control will impair
functioning. If the following actions do not rectify the problem, consult an authorised dealer.
Problem
No sound.
The hi-fi system does not react when
the buttons are pressed.
The remote control does not work.
Poor radio reception.
Tracks on a CD are skipped.
CD-Rs or CD-RWs are not played
back, or are played back incorrectly.
_____________________________________
Possible cause/remedy
The volume setting is too low – increase the volume.
The headphones are plugged in – disconnect the head-
phones.
The power cord is incorrectly connected. Connect it
properly.
Mute is activated, deactivate Mute.
Static electrical discharge. Switch off the hi-fi system,
disconnect the power cable and plug it in again after a
few seconds.
The battery is flat. Replace the battery.
The remote control is out of range of the hi-fi.
Weak antenna signal, check the antenna.
Weak FM-stereo signal, switch to Mono.
Interference from electrical devices such as televisions,
video recorders, computers, neon lamps, thermostats or
motors. Keep the hi-fi system away from such devices.
The CD is damaged or dirty – replace the CD or clean it.
The RANDOM function is activated. Deactivate the
function.
Faulty software or hardware settings during burning or the
CD itself.
Check the components of your CD burner/software or
change the CD being used.
Advertisement
Table of Contents
