Table of Contents
Advertisement
6 — Configuring frame relay connections
Procedure 6-3 Disconnecting an endpoint
A connection can be disconnected by disconnecting either endpoint.
CONFIG — CONNECT — <endpoint>
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
6.2
Configuring frame relay traffic parameters
Table 6-1 lists the traffic parameters that can be configured on the ST591s.
Parameter
FR service category
Policing
Rates
Note
(1)
Access rate is the effective maximum bandwidth of a frame relay port.
Procedure 6-4 Configuring the service category
CONFIG — CONNECT — <endpoint>
REAL_TIME or LOW_DELAY or COM_THRUPUT or BEST_EFFORT*
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
For further information on service categories, refer to Alcatel 7350 ASAM Technical
Practices.
6-4
— DISCONNECT
Table 6-1 Traffic parameters
Possible values
REAL_TIME
LOW_DELAY
COM_THRUPUT
BEST_EFFORT
Enable, Disable
CIR
0 - AR kb/s
Bc
0 - 65535 kb/s
Be
0 - 65535 kb/s
— TRAFFIC — FROM_1 2 — FR_SERV_CAT —
Default value
BEST_EFFORT
Enable
(1)
0 kb/s
0 kb/s
AR kb/s
Speed Touch 591s Technical Practices
90-8785-01
February 2001
Advertisement
Table of Contents
