Table of Contents
Advertisement
13 — Maintenance and file transfers
13.1
System maintenance
The following maintenance options are available for the Speed Touch 591s:
•
specifying the active memory bank, erasing memory banks, and performing other
software maintenance tasks
•
forcing the Speed Touch 591s to boot up
•
resetting the Speed Touch 591s
•
displaying the SEEP
•
displaying TCA profiles (frame relay Speed Touch 591s only)
The first four options are accessible through the MAINT — SYSTEM — RELEASE
screen on the NMTI (see Figure 13-1). TCA profiles are displayed through the
MAINT — SYSTEM — TCA_PROFILE screens on the NMTI. Figure 13-2 shows
an example of a screen for FRCC-type TCA profiles.
Speed Touch 591s
Object
PLNT
Bank 1
Bank 2
Bootprom
Cause of last reboot : Usr
MAINT SYSTEM RELEASE
1-NEXT_BANK
6-RESET_NIU
13-2
Figure 13-1 Speed Touch 591s maintenance system release screen
Generic
Card Ser. No.
Status
Software Generic
OK
A29214-B1-0B
Current
A29214-B1-0A
Current
A29204-B1-06
2-ERASE_BANK1
7-MORE
Every time the ERASE_NVM command is executed, the
Note —
user port reverts to the disabled state and must be enabled again (the
interface type must also be configured again if the interface is not
V.35, the default setting). Refer to section 5.1 for details on how to
configure the interface type.
Node name
Maj:Alrm:5
Mktg. Part No.
K12345
90-0001-01-02-AAAA
3-ERASE_BANK2
4-FORCE_BOOT
8-CANCEL
9-QUIT
Speed Touch 591s Technical Practices
90-8785-01
Date
Time
5-ERASE_NVM
0-
February 2001
Advertisement
Table of Contents
