Table of Contents
Advertisement
Procedure 5-5 Restoring default values for the control leads
CONFIG — OBJECT — PORT — <U>
Table 5-1 shows the default values for the control leads.
Procedure 5-6 Configuring the clocking mode
CONFIG — OBJECT — PORT — <U>
EXTERNAL
Procedure 5-7 Configuring inverted clocking
CONFIG — OBJECT — PORT — <U>
ENABLE or DISABLE*
Procedure 5-8 Configuring the clock rate
CONFIG — OBJECT — PORT — <U>
kb/s or 19.2 kb/s or 48 kb/s or n*64 kb/s <value>
where value is the value of n (1 to 32), used as a multiplying factor for 64 kb/s
Speed Touch 591s Technical Practices
February 2001
90-8785-01
5 — Configuring frame relay port parameters
— OPTIONS — CTRL_LEADS — SET_DEFAULT
— OPTIONS — CLOCKING — MODE — SLAVE* or
— OPTIONS — CLOCKING — TX_INVERT —
— OPTIONS — CLOCKING — CLOCK_RATE — 9.6
5-5
Advertisement
Table of Contents
