Table of Contents
Advertisement
12 — Configuring T1/E1 CE channel groups
12.1
Configuring channel groups
The softkey structure for configuring channel groups on the T1 circuit emulation
version is shown below.
ADD_CHANNEL <channel>
One or more channels of an E1 or T1 CE port in SDT mode can be grouped into a
channel group. The channel group acts as a single super-rate endpoint. The channels
in the group can be contiguous or noncontiguous; however, the channels must
maintain their end-to-end time ordering. Refer to Alcatel 7350 ASAM Technical
Practices for further details.
A channel group consists of 1 to 24 channels for a T1 CE port and 1 to 31 channels
for an E1 CE port. For an E1 CE port in CAS mode, channel 16 is reserved for
signaling and cannot carry data. A channel can belong to only one channel group.
A channel group is identified by the lowest-numbered channel in the group. For
example, if the channel group consists of channels 4, 5, 6, and 7, the channel group
is identified as CG4.
12-2
CONFIG
OBJECT
CHANNELGROUP <endpoint>
NAME <name>
DEL_CHANNEL
ALL
Channel groups can be configured only when the AAL
Note —
service is configured to SDT. No channel groups can be configured in
UDT mode.
OPTIONS
NUM_DATA_OCT
PLAYOUT_BUFF <value>
<value>
Speed Touch 591s Technical Practices
90-8785-01
SHOW_GROUPS
SK002852
February 2001
Advertisement
Table of Contents
