Mouse Emulation Control; Mouse Port-Switching; Spc Mode; Power On Detection - ATEN CS1762A User Manual

Chapter 4. Hotkey Operation

Mouse Emulation Control

The default setting is enabled. To disable, do the following:
1. Invoke HSM (see page 22
).
2. Press [M].
This procedure is a toggle. Repeat to enable.

Mouse Port-switching

The Mouse Port-switching function can be enabled or disabled. The default
setting is disabled. To enable, do the following:
1. Invoke HSM (see page 22).
2. Press [W] [Enter].
This procedure is a toggle. Repeat to disable.
Note: The feature is only supported when mouse emulation is enabled. See
Mouse Emulation Control, above.

SPC Mode

To set the keyboard/mouse to use SPC mode so that it can work under special
operating systems as a standard (104 key) keyboard/mouse, do the following:
1. Invoke HSM (see page 22).
2. Press [F1].

Power on Detection

With Power on Detection if the focus computer is powered off, the switch will
automatically switch to the next powered-on computer. Power on Detection
can be enabled or disabled. The default setting is enabled. To disable Power on
Detection, do the following:
1. Invoke HSM (see page 22).
2. Press [E].
This setting is a toggle. Repeat to enable.
27