Firmware Upgrade Mode; Restore Default Settings; Video Dynasync; Alternate Manual Port Selection Settings - ATEN CS1762A User Manual

CS1762 / CS1764
A A

Firmware Upgrade Mode

To set the CS1762
1. Invoke HSM (see page 22).
2. Key in: upgrade
3. Press [Enter]. The orange front panel LEDs flash to indicate Firmware
Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
See The Firmware Upgrade Utility, page 33, for details.

Restore Default Settings

To reset the CS1762
following:
1. Invoke HSM (see page 22).
2. Press [R] [Enter].
See Hotkey Default Settings, page 46

Video DynaSync

Video DynaSync is ATEN's exclusive technology that eliminates boot-up
display problems and optimizes resolution when switching between ports. To
invoke Video DynaSync, do the following:
1. Invoke HSM (see page 22)
2. Press [D].
Note: If the monitor is disconnected and reconnected, the CS1762
CS1764

Alternate Manual Port Selection Settings

To toggle between the default and the alternative front panel pushbutton
manual port selection settings, do the following:
1. Invoke HSM (see page 22)
2. Press [S].
See Alternate Manual Port Selection Settings, page 17, for full details.
26
User Manual
/ CS1764 to Firmware Upgrade Mode, do the following:
A A
/ CS1764 to its default hotkey settings, do the
A A
re-executes Video DynaSync.
A
/
A