Planet ADN-4000 User Manual page 29

802.11n wireless adsl 2/2+ router
Hide thumbs Also See for ADN-4000:
Table of Contents

Advertisement

The following table describes the labels in this screen.
Parameter
Username
Password
Encapsulation
Bridge Interface
Connection
TCP MSS Option
Get IP Address
Static IP Address
IP Subnet Mask
Gateway
NAT
Default Route
TCP MTU Option Enter TCP MTU Value here.
Dynamic Route
Multicast
Connection
Setting: For PPPoE/PPPoA connection, you can select Always on or
Connect on-demand. Connect on demand is dependent on the traffic. If there is
no traffic (or Idle) for a pre-specified period of time, the connection will tear down
automatically. And once there is traffic send or receive, the connection will be
automatically on.
IP
Address: For PPPoE/PPPoA connection, you need to specify the public IP
address for this ADSL Router. The IP address can be either dynamically (via
DHCP) or given IP address provide by your ISP. For Static IP, you need to specify
the IP address, Subnet Mask and Gateway IP address.
NAT: Select this option to Activate/Deactivated the NAT (Network Address
Translation) function for this VC. The NAT function can be activated or
deactivated per PVC basis.
Description
Enter your username for your PPPoE/PPPoA connection.
Enter your password for your PPPoE/PPPoA connection.
Select your encapsulation type from the dropdown list.
Select whether the Interface will be Activated or Deactivated.
Select whether your connection is always on or if it connects on
demand. If on demand, specify how many minutes the
connection may be idle before it disconnects.
Enter the TCP MSS you wish to use here.
Choose whether the ROUTER obtains the IP address statically
or dynamically.
Enter the static IP address here. Only if you chose Static above.
Enter the IP subnet mask here. Only if you chose Static above.
Enter the gateway here. Only if you chose Static above.
Select whether NAT is Enabled or Disabled.
Select whether this PVC will be the default route for Internet
data.
Select the RIP type and direction from the dropdown lists.
Select the multicast protocol you wish to use from the dropdown
list.
29

Advertisement

Table of Contents
loading

Table of Contents