Planet ADN-4000 User Manual page 10

BLINKING WPS function is enabled
ON
ADSL
BLINKING No Connection
ON
LAN1-4
OFF
Blinking
Rear Panel of ADN-4000
Rear panel Port and Button Definition
Port Description
Reset
Power Power connector with 12V DC 1A.
Wi-Fi Protected Setup (WPS) is the simplest way to build connection between
wireless network clients and this ADSL router. Press this button on the router and
enable WPS function of the wireless clients, the router and clients will
WPS Button
automatically configure the security key and connect directly. Please note that the
router will wait for WPS requests from wireless clients in 2 minutes after the WPS
button is pressed.
Router is successfully connected to a device through the corresponding port (1, 2, 3,
LAN1-4 or 4). If the LED is flashing, the Router is actively sending or receiving data over
that port.
ADSL The RJ-11 connector allows data communication between the modem and the
Connector ADSL network through a twisted-pair phone wire.
Connected to an ADSL DSLAN successfully
The LAN cable is connected to the router
No network connection
Network traffic transferring or receiving through the LAN port
Reboot router: press the reset button for less than 5 seconds, and it will keep
your original configurations.
Load factory default setting: press the reset button for longer than 5 seconds
and the router will reset itself to the factory default settings (warning: your
original configurations will be replaced with the factory default settings)