Planet ADN-4000 User Manual page 12

Select a suitable place on the network to install the ADN-4000.
NOTE
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the ADN-4000. Both
10Base-T and 100Base-TX connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable. Any
LAN port on the ADN-4000 will automatically function as an "Uplink" port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADN-4000 (the RJ-11
connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the ADN-4000. Use only the power adapter provided.
Using a different one may cause hardware damage.
5. Check the LEDs
• The PWR LED should be ON.
• The WLAN LED should be flash, when wireless AP is ready.
• The ADSL LED should be ON if ADSL line is connected.
• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is also
ON.)
Note: You must use the power adapter shipped along with the router, do NOT use any other power
adapter from other sources.
For best Wireless reception and performance, the ADN-4000 should be
positioned in a central location with minimum obstructions between the
ADN-4000 and the PCs.
Also, if using multiple Access Points, adjacent Access Points should use
different Channels.