Automatic 2-Sided Printing Problems; Printer Is Making Unusual Noises; Paper Tray Will Not Close; Condensation Has Formed Inside The Printer - Xerox WorkCentre 6605 User Manual

Troubleshooting

Automatic 2-Sided Printing Problems

Probable Causes
Unsupported or incorrect paper.
Incorrect setting.

Printer is Making Unusual Noises

Probable Causes
There is an obstruction or debris inside the
printer.

Paper Tray Will Not Close

Probable Causes
The paper tray does not fully close.

Condensation has Formed Inside the Printer

Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is
located in a warm room. Condensation can form in a printer after it has been sitting in a cold room
that is heated quickly.
Probable Causes
The printer has been sitting in a cold room. Allow the printer to operate for several hours at room
The relative humidity of the room is too
high.
234 WorkCentre 6605 Color Multifunction Printer
User Guide
Solutions
Ensure that you are using a supported paper size and weight for
2-sided printing. Envelopes and labels cannot be used for 2-sided
printing. For details, see
for Automatic 2-Sided Printing
Standard Paper Sizes for Automatic 2-Sided Printing
115.
In the print driver Properties, select 2-Sided Print on the
Paper/Output tab.
Solutions
Turn off the printer and remove the obstruction or debris. If you
cannot remove it, contact your Xerox representative.
Solutions
• The paper tray lift plate is not locked down. Push down on the
paper stack at the back of the tray until it locks down.
• Some debris or an object is blocking the tray.
• The tray is hanging up on the table or shelf on which it is
located.
Solutions
temperature.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications.
Supported Standard Types and Weights
on page 114 and Supported
on page