Bodywork - Fiat 500 Owner's Handbook Manual

fig. 7
SPRAY NOZZLES
Windscreen washer fig. 7
If the jet of fluid is inadequate, firstly check
that there is fluid in the reservoir: see
"Checking fluid levels" in this section).
Then check that the nozzle holes are not
clogged, if necessary use a needle.
The windscreen jets are directed by ad-
justing the angle of the nozzles.
Fluid jets shall be directed at about
height from the window upper edge.
IMPORTANT For the versions with sun-
roof, before operating the front sprays,
ensure that the sunroof is closed.
144
F0S0110m fig. 8
Rear window wiper fig. 8
Rear window washer jets are fixed.
The nozzle holder is on the rear window.
1
/
3

BODYWORK

PROTECTION FROM
ATMOSPHERIC AGENTS
The main causes of corrosion are the fol-
lowing:
❒ atmospheric pollution;
❒ salty air and humidity (coastal areas, or
F0S0111m
hot humid climates);
❒ seasonal environment conditions.
Not to be underestimated is also the abra-
sive action of wind-borne atmospheric
dust and sand and mud and gravel raised
by other cars.
On your car, Fiat implemented the best
manufacturing technologies to effectively
protect the bodywork against corrosion.
These are the most important:
❒ painting products and systems which
give the car particular resistance to cor-
rosion and abrasion;
❒ use of galvanised (or pre-treated) steel
sheets, with high resistance to corro-
sion;
❒ spraying the underbody, engine com-
partment, wheelhouse internal parts
and other parts with highly protective
wax products;