Fiat 500 Owner's Handbook Manual page 107

fig. 2
To change a wheel proceed as follows:
❒ stop the car in a position so that it is
not a danger for on-coming traffic and
where you can replace the wheel safe-
ly. The ground must be flat and com-
pact;
❒ Turn the engine off and pull up the
handbrake;
❒ Engage first gear or reverse;
❒ lift the boot mat A-fig. 2;
106
F0S0126m
fig. 3
❒ loosen the fastener B-fig. 3;
❒ take out the tool container C and take
it near to the wheel to be changed;
❒ take out the small spare wheel D;
❒ to remove the hub cap use the supplied
screwdriver, prising on the special slit
on the outer rim;
fig. 4
❒ for the vehicles equipped with alloy
rims, remove the pressure-fitted hub
cap using the supplied screwdriver;
❒ loosen by about one turn the fasten-
ing bolts of the wheel to be replaced
with the wrench provided E-fig. 4;
❒ turn the jack handle to partially open it;
F0S0127m
F0S0128m