Add A Camera For Monitoring - TRENDnet TV-IP501W User Manual

Hide thumbs Also See for TV-IP501W:

Table of Contents

The Add camera menu is presented the first time the

used to add cameras to the user interface for monitoring. After the first time running the software, this

menu can be accessed at anytime from the configuration menus. The configuration menus are described

in a later section of this chapter. Notice that the

eligible cameras running on the network.

To add a camera to the

Check the list of cameras detected by the

software, if the camera you want does not

appear on the list then clicks the Refresh

button to conduct another search. If it still

does not appear, check the IP address of the

camera and click on the Input the location of

camera menu tab and skip ahead to step 2.1

Select the camera to add from the list, enter

the administrator's user name (ID :) and

password, a preview of the live video display

will appear. Click the OK, add this camera

button, a confirmation message informs

when the camera is connected and added to

the IPViewPro monitoring group. Repeat this

procedure for all the cameras being added.

Click the Exit button after all the cameras

have been added.

If the camera does not appear listed, click the Input the location of camera tab above the list to view a

new menu. Enter the IP address or the URL (for example, ipcam.ddns.org) of the camera being added,

type the user name and password and click the Preview to verify that a link can be established. The live

video of the camera should appear in the Live preview display. If a link cannot be established, run the

Setup Wizard software for the camera and verify the correct IP address.

3. Once the cameras have been added, they are ready to be used in the main IPViewPro user interface.

Close the Add camera menu (click Exit) to go to the main user interface. See below for a description.

TV-IP501W Internet Camera User Manual

Add a camera for monitoring

IPViewPro 2.0

user interface, follow these instructions:

IPViewPro 2.0

software has automatically detected

software is launched. This menu is

Table of Contents