Table of Contents
Advertisement
Camera Hardware Components
Below is a summary description of the camera hardware.
Audio Mic
DC 5V
Reset
10/100 Ethernet
LAN Port
Camera Stand
Connector
PWR
LNK
TV-IP501W Internet Camera User Manual
Used to capture sounds
The DC power input connector is located on the back of the camera's rear panel and
is labeled DC5V with a single jack socket to supply power to the camera. Power will
be generated when the power supply is connected to a wall outlet.
The Reset procedure will be initiated when this button is pressed. The Factory
Reset procedure will be initiated when this button is pressed and hold for five
seconds.
This RJ-45 connector is used to connect to a 10Base-T Ethernet or to a
100Base-TX Fast Ethernet network. This port supports the N-Way protocol &
Auto-MDIX, allowing the camera to automatically detect or negotiate the
transmission speed of the network.
It's located on the top and the bottom panel of the camera. This hole is used to
connect the camera's stand to the camera by attaching the screw head of the
camera stand into the screw hole of the camera.
LED Indicators
This LED indicator lights blue when the camera is powered on. It remains dark when
powered off.
A steady orange light indicates that the camera has a good connection to
LAN/WLAN. It starts flashing to indicate that the camera is sending and receiving
data to and from the LAN.
8
Advertisement
Table of Contents
