Table of Contents
Advertisement
Page 22
Ringer Controls
Changing the Ringer Volume
Setting the Ringer Timeout
INDeX - DT1 Phone Guide
While altering the volume, the phone rings.
To change the ringer volume:
1. Without lifting the handset, dial FEATURE .
2. Short-chirp: Dial 30 (ringer volume).
3. Double-tone: Dial the phone's 4-digit passcode. If you make a
mistake, dial
to restart entry.
4. Deep double-ring: Passcode not accepted. Dial the passcode again
or dial FEATURE to stop.
5. Repeated ringing: Passcode accepted. Dial
level. Repeat until you hear the volume preferred, then dial #.
6. Short-chirp: Dial FEATURE to finish.
The ringer timeout controls several actions:
– Callback: How long a callback rings before cancelling.
– Group hunting: How long calls to a group of which your DT1 is a
member, ring your DT1 before trying another member.
– Divert on no answer: How long calls ring at your phone before the
system uses Divert on No Answer if set.
To set the ringer timeout:
1. Without lifting the handset, dial FEATURE .
2. Short-chirp: Dial 13 (ringer timeout).
3. Double-tone: Dial the phone's 4-digit passcode. If you make a
mistake, dial
to restart entry (see page 24).
4. Deep double-ring: Passcode not accepted. Either dial the passcode
again or dial FEATURE to stop.
5. Double-ring: Timeout already set. Either dial
FEATURE to stop.
6. Single-ring: No timeout set. Either dial a timeout (0 to 999 seconds -
10 seconds 3 rings) or dial FEATURE to stop.
7. Short-chirp: Dial FEATURE to finish.
for the next volume
to cancel it or
38GDE00001SAC - Issue 4 (January 1999)
Advertisement
Table of Contents
