Table of Contents
Advertisement
Advanced System Features (Cont'd)
If a user code is required for any part of the Speed
following prompt appears. Otherwise, the Speed
begins.
ENTER USER CODE
Enter your user code. The programmed Speed
automatically.
Using Relay Mode (#70)
Your system may be set up so that certain lights or other devices can be
turned on or off by using the #70 command from a touchpad. Ask your
installer if this has been done in your system.
To activate relays from Console Emulation Mode or a Custom English
touchpad
described below.
ENTER DEVICE NO.
00=QUIT
NN
DEVICE IS OFF
HIT 0=OFF , 1=ON
NN
DEVICE IS OFF
HIT THE "T" KEY
Temporary Schedules
Delaying the Closing Time Using
Your system's programmed schedules may automatically arm the system at
a predetermined time. In the event a user must stay on the premises later
90
////
,
enter 4-digit security code + [#] +70. Follow the touchpad prompts
oice:
V
01
Enter the 2-digit number of the device to be activated.
Note that if an invalid number is entered, the system will simply ask
you to reenter the number.
oice:
V
descriptor ON ENTER 1, FOR voice descriptor OFF ENTER
0"
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and voice descriptor is the
relay voice descriptor programmed by the installer.
oice:
V
ENTER 00 NOW"
From a touchpad, press / to continue. The ENTER DEVICE NO.
prompt will appear.
From a telephone touchpad, enter 00 to exit, or enter the next relay
number to be programmed. The current on/off state of that relay will be
annunciated as described above. Alternatively, if 6 seconds elapses
with no key depression, the 4285 or 4286 VIP module will annunciate
the "ENTER DEVICE CODE NOW" message.
K ey sequence, the
K ey sequence automatically
K ey sequence will begin
"ENTER DEVICE CODE NOW"
" voice descriptor DEVICE nn ON/OFF. FOR voice
" voice descriptor DEVICE nn ON/OFF. TO EXIT
chedules
S
Advertisement
Table of Contents
