Operations Cannot Be Performed Through The Remote Control Unit; Display On This Unit Shows Nothing - Denon AVR-X2000 Owner's Manual

Contents

2 Operations cannot be performed through the remote control unit

Symptom
Operations cannot be performed
through the remote control unit.

2 Display on this unit shows nothing

Symptom
Display is off.
Front panel Display
Connections Playback
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an
angle of within 30°.
• Remove any obstacle between this unit and the remote control unit.
• Insert the batteries in the proper direction, checking the q and w marks.
• The set's remote control sensor is exposed to strong light (direct sunlight, inverter type
fluorescent bulb light, etc.). Move the set to a place in which the remote control sensor will
not be exposed to strong light.
• The operation target zone does not correspond to the zone setting specified on the remote
control unit. Press MAIN or ZONE2 to select the zone to operate.
• When using a 3D video device, the remote control unit of this unit may not function due to
effects of infrared communications between units (such as TV and glasses for 3D viewing). In
this case, adjust the direction of units with the 3D communications function and their distance
to ensure they do not affect operations from the remote control unit of this unit.
• Set "Dimmer" on the menu to something other than "Off".
• When the sound mode is set to PURE DIRECT, the display is off.
Rear panel
Settings
Cause/Solution
Cause/Solution
177
Remote
Tips Appendix
Page
117, 125
Page
Index
7
7
–
7
–
–
167
101