Denon AVR-X2000 Owner's Manual page 16

Contents
Q2 Q1 Q0 o i u
q
q FM/AM antenna terminals (ANTENNA)
Used to connect FM and AM antennas (vpage 53).
w Speaker terminals (SPEAKERS)
Used to connect speakers (vpage 23).
e Video connectors (VIDEO)
Used to connect devices
(vpage 33, 34).
r Component video connectors (COMPONENT VIDEO)
Used to connect devices equipped with component video connectors
(vpage 33, 34).
t AC inlet (AC IN)
Used to connect the power cord (vpage 42).
y HDMI connectors
Used to connect devices equipped with HDMI connectors
(vpage 30, 31, 35).
Front panel Display
Connections Playback
y
w e r
equipped with video
Rear panel
Settings
u
Digital audio connectors (DIGITAL AUDIO)
t
Used to connect devices equipped with digital audio connectors
(vpage 33, 34).
i Network connector (NETWORK)
Used to connect this unit to the network (vpage 40).
o PRE OUT connectors
Used to connect a subwoofer with a built-in amplifier or an external
power amplifier (vpage 24, 116).
Q0 REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this
unit and external devices from a different room (vpage 41).
Q1 Analog audio connectors (AUDIO)
Used to connect devices equipped with analog audio connectors
(vpage 33, 34).
Q2 RS-232C connector
The RS-232C serial port is provided to allow compatibility with an
external home automation controller. Consult the owner's manual
of the home automation controller for more information about serial
connectors
control of this unit. The serial port allows two-way control and status
via an external home automation controller.
NOTE
• Do not touch the inner pins of the connectors on the rear panel. Electrostatic
discharge may cause permanent damage to the unit.
16
Remote
Tips Appendix
Index