Denon AVR-X2000 Owner's Manual page 149

Contents
3
Connect the Setup and measurement microphone to
the SETUP MIC jack of this unit.
When the Setup and measurement
microphone is connected, the
following screen is displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
Front panel Display
Connections Playback
Rear panel
Settings
4
Select "Start" and then press ENTER.
Audyssey® Setup can also make the following settings.
• Amp Assign
The signal output from the SURROUND BACK speaker terminals
of this unit can be switched to match your speaker environment.
Refer to "Amp Assign" (vpage 155).
• Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of surround
back speakers.
5
Select "Next" and then press ENTER.
6
Select "Begin Test" and then press ENTER.
• Measurement requires several minutes.
NOTE
• If "Caution!" is displayed on TV screen:
Go to "Error messages" (vpage 153). Check any related items, and
perform the necessary procedures.
When measuring has stopped
q Press BACK to display the popup screen.
w Press o to select "Yes", and then press ENTER.
149
Remote
Tips Appendix
Index