Playback In Zone2 - Denon AVR-X2000 Owner's Manual

Contents Connections

Playback in ZONE2

ZONE2
Input source
select buttons
MUTE
:
Front panel Display
Playback
1
2
POWER
X
3
VOLUME
df
2 Adjusting the volume
117
Rear panel
Settings Tips
Press ZONE2 to switch the zone mode to the ZONE2.
Press POWER X to turn on the ZONE2 power.
(
The indicator on the display lights.
%
• Also press input source select button when in standby mode, the
power turns on.
• When POWER X is pressed, ZONE2 turns off.
• Power in ZONE2 can be turned on or off by pressing ZONE2 ON/
OFF on the main unit.
Press the input source select button to select the input
source to be played.
The audio signal of the selected source is output to ZONE2.
%
• In ZONE2, you can select iPod/USB, TUNER, NETWORK or an
input source with an analog audio input connector.
• To perform an operation with the main unit, press ZONE2
SOURCE.
Each time you press ZONE2 SOURCE, the input source changes.
Use VOLUME df to adjust the volume.
• At time of purchase, "Volume Limit" (vpage 166) is set to "70
(–10dB)".
%
• Turn MASTER VOLUME after pressing ZONE2 SOURCE on the main unit to
adjust the sound volume.
Remote Index
Appendix