Error Messages - Denon AVR-X2000 Owner's Manual

Contents

Error messages

An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples
Microphone or Speaker is
None
Ambient noise is too high or
level is too low
Front R : None
Front R : Phase
Front panel Display
Connections Playback
Error details
• Setup and measurement microphone is not
detected.
• Not all speakers could be detected.
• There is too much noise in the room.
• Speaker or subwoofer sound is too low.
• The displayed speaker could not be
detected.
• The displayed speaker is connected with
the polarity reversed.
Rear panel
Settings
• Connect the included Setup and measurement microphone to the
SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the
speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be displayed even if
the speaker is properly connected. If you are sure the connection is
correct, use p to select "Skip Error", then press ENTER.
153
Remote
Tips Appendix
Measures
Index