Operations Cannot Be Performed Through The Remote Control Unit; Display On This Unit Shows Nothing - Denon AVR-X5200W Owner's Manual

Contents Connections
o Operations cannot be performed through the remote control unit
Symptom
Operations cannot be
0
performed through the
0
remote control unit.
0
0
0
0
0
0
o Display on this unit shows nothing
Symptom
Display is off.
0
0
Front panel Display
Playback
Batteries are worn out. Replace with new batteries.
Operate the remote control unit within a distance of about 7 m from this unit and at an angle of within 30°.
Remove any obstacle between this unit and the remote control unit.
Insert the batteries in the proper direction, checking the q and w marks.
The set's remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb
light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light.
The operation target zone does not correspond to the zone setting specified on the remote control unit.
Press MAIN, Z2 or Z3 to select the zone to operate.
The remote control unit operating mode is used to operate other devices. Press MAIN to set the operating
mode to AVR.
When using a 3D video device, the remote control unit of this unit may not function due to effects of
infrared communications between units (such as TV and glasses for 3D viewing). In this case, adjust the
direction of units with the 3D communications function and their distance to ensure they do not affect
operations from the remote control unit of this unit.
Set "Dimmer" on the menu to something other than "Off".
When the sound mode is set to "Pure Direct", the display is off.
Rear panel
Settings
Cause / Solution
Cause / Solution
261 Remote
Tips Appendix
Page
Page
Index
9
9
－
9
－
161
252
－
243
130