Error Messages - Denon AVR-1611 Owner's Manual

ENGLISH

Error messages

An error message is displayed if Audyssey ® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.
If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples
Caution
MultEQ
Microphone:None
F
or
Speaker :None
Retry
Cancel
[ENT]:Retry
Caution
MultEQ
Ambient noise is
F
too high or
Level is too low.
Retry
Cancel
[ENT]:Retry
Caution
MultEQ
Front
R :None
Retry
Cancel
Skip
[ ]:Up/Down [ ]:CH
Caution
MultEQ
Front
L :Phase
Retry
Cancel
Skip
[ ]:Up/Down [ ]:CH
10
Remote control operation
buttons
Error details
• The connected setup microphone is broken, or a
device other than the supplied setup microphone
is connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• There is too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• The displayed speaker could not be detected.
• The displayed is connected with the polarities
reversed.
Move the cursor
(Up/Down/Left/Right)
Measures
• Connect the included setup microphone to the
SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise or
move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction
in which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
ui
correct, press to select "Skip", then press
ENTER
.
Confirm the setting
Parameter Check
This function enables you to check the measurement results and
equalizer characteristics after Audyssey Auto Setup.
1
Use to select "Parameter Check" and then
ui
ENTER
press .
2
Use to select the item you want to check, then
ui
press ENTER .
3-2.Parameter Check
Speaker Config.Check
Distance Chenck
Channel Level Check
Crossover Freq.Check
EQ Check
Restore
[ENT]:Select [RTN]:Back
Speaker Config. Check Check the speaker configuration.
Distance Check Check the distance.
Channel Level Check Check the channel level.
Crossover Freq. Check Check the crossover frequency.
EQ Check Check the equalizer.
• If "EQ Check" is selected in step 2, press ui
curve ("Audyssey" or "Audyssey Flat") to be checked.
Use o p to switch the display between the different speakers.
3
RETURN
Press .
The confirmation screen reappears. Repeat steps 2 and 3.
Retrieving Audyssey Auto Setup settings
If you set "Restore" to "Yes", you can return to Audyssey Auto Setup
measurement result (value calculated at the start by MultEQ ® ) even
when you have changed each setting manually.
Return to previous menu
to select equalizing