3-4-7.Flash Adjustment; 3-4-8.End Setting - FujiFilm FinePix A201 Service Manual

3. Adjustment
3-4-7. Flash Adjustment
Cautions during adjustments.
1.Set the camera and gray chart. Refer to 3-2-6, Environment Settings for Flash Adjustment
2.In the flash adjustment, carry out the adjustments by making the surrounding area dark
so that there will be no influence from external light sources.
Procedure
1) From the adjustment item menu, press the [F6] key and perform Flash adjustment.
2) The adjustment begins according to the instruction of the screen when setting necessary for adjusting
flash ends.<Fig.4-12, 4-13>
Flash adjustment
Please set lens position to [INF].
Please set gray chart 100cm from Lens.
Press the <Enter> key when it is possible to prepare.
<Fig.4-12> Flash adjustment screen

3-4-8.End Setting

Note: After end settings, the system is not in the camera jig mode.
To perform further adjustment, first enter the camera jig mode again.
Procedure
1) When all adjustments have been made, press the [F8] key and perform End setting.
2) Follow the on-screen instructions on the PC and select the [Model ID] and [Repair Base ID].
<Fig.4-14,4-15>
USB ID
The model is selected from an undermentioned list.
<A> FinePix A101 U-model
<B> FinePix A101 E-model
<C> FinePix A101 EG-model
<Fig.4-14> Model ID input screen
28
FinePix A201 (U/E/EG) SERVICE GUIDE
Fx_A201.ff
Flash adjustment
Charge - luminescence (1st time)
Charge - luminescence (2nd times)
Charge - luminescence (3rd times)
Average value(hex)
Correction value
Press the [Enter] key.
<Fig.4-13> Complete of Flash adjustment screen
Fx_A201.ff
Please remove DC-IN Jack.
Press the [Enter] key, ALL adjustment end.
= 23
= 24
= 24
= 24
= 3
<Fig.4-15> End of adjustment screen
Fx_A201.ff
Fx_A201.ff