Table of Contents
Advertisement
3. Adjustment
3-4.Adjustment
3-4-1.Procedures of the Camera Jig Mode
Procedure
1) Please set the mode dial to [CAM] mode.
2) Please set the lens position to [INF].
3) Please input 3V from DC-IN Jack.
4) Please connect the USB cable.
5) Please open the battery cover.
(Please put in LCD adjustment card (SSFDC) when you adjust the LCD adjustment.)
6) Please holding down the [Release] button, them trun on the camera.
7) When a green lamp on the side of the finder lights, completely camera jig mode.
Important Notes
* When connected to a personal computer while in the camera jig mode, the camera is not
recognized as a removable disk.
* The camera's power switch does not work while in the camera jig mode. If a problem
occurs during adjustment, switch off the power by disconnecting the DC jack. To switch
on, reconnect the DC jack, then switch on the power to the camera.
* To quit the camera jig mode, use [End Settings] in the adjustment program.
3-4-2.Using the Adjustment Program
Procedure
1) Once the initial settings of the adjustment software have been completed, end "FFW.exe" and start
"FFW.exe" once again.
2) Follow the instructions on the screen to set the camera to jig mode. <Fig.4-1>
3) Press the [Enter] key and follow the instructions to make each of the adjustments using the menu
screen. <Fig.4-2>
FinePix A201 PC adjustment software
Procedures of the camera jig mode.
1) Please set the mode dial to [CAM] mode.
2) Please set the lens position to [INF].
3) Please input 3V from DC-IN Jack.
4) Please connect the USB cable.
5) Please open the battery cover.
Please put in LCD adjustment card (SSFDC)
when you adjust LCD adjustment.
6) Please holding down the [Release] button,
them trun on the camera.
7) When a green lamp on the side of the finder lights,
please press the [Enter] key!
<Fig.4-1> Program start screen
24
FinePix A201 (U/E/EG) SERVICE GUIDE
Fx_A201.ff
FinePix A201 PC adjustment software
[F1] Battery adjustment
[F2] LCD adjustment
[F3] CCD data input
[F4] CAM adjustment
[F5] Flash adjustment
[F8] End setting
[Q] Quit
Fx_A201.ff
Firmware Ver.= 206
<Fig.4-4> Menu screen
Advertisement
Table of Contents
