3-3-7.Use Of Each Command; Adjustment - FujiFilm FinePix A201 Service Manual

FinePix A201 (U/E/EG) SERVICE GUIDE

3-3-7.Use of each command

An explanation and the use of each command when it changes the user's program.
Menu Command
Operation Start
Stop
Halt
Step 0
Exit
Program Re load
Select
Edit
Data ad[]
rd[]
SW
fsw
EVR
Mode File Recording
NGSTOP
STEP
LINE
AUTO
Setting OKNG clearr
Customize
Auto Adjustment
Help Help
Help (FF)
FOCAS
Version
It is possible to edit the user program, but it is possible that trouble could occur after changes are
made. So, please do not edit program unless instructed to do so.
Content
General operation command (starts the user program).
General operation command (ends the user program).
General operation command (Halts the user program temporarily).
Do not use this command.
General operation command (Closes the user program).
Reloads the user program (*.ff).
(Be sure to reload the user program after editing.)
Selects the user program (*.ff).
(Selects 'sj8.ff' when selecting the user program.)
Edits the user program (*.ff).
(Use this when it is necessary to edit the user program.)
Do not use this command.
Do not use this command.
Do not use this command.
Do not use this command.
Do not use this command.
Do not use this command.
Stops the program if an adjustment is NG.
Do not use this command.
Do not use this command.
Do not use this command.
Do not use this command.
Performs setting of each mode.
Performs 'Auto Adjust' settings in the user program.
This command cannot be used.
This command cannot be used.
This command cannot be used.
Version information on the basic software.

3. Adjustment

Fx_A201.ff
23