2.
Remove the TouchPad bracket (2).
3.
Release the two pieces of grounding tape (1) that connect the TouchPad to the top cover.
4.
Remove the four Phillips PM2.5×2.5 broad head screws (2) that secure the TouchPad to the
top cover.
NOTE:
crucial to the performance of the TouchPad.
5.
Lift the rear edge of the TouchPad (4) until it rests at an angle.
88
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
The second and third screws include two rubber washers (3). These washers are