AOpen AX3L User Manual page 67

AWARD BIOS
Integrated Peripherals
UART Mode Select
Standard
HPSIR
ASKIR
•
Standard
default setting.
•
-
HPSIR
system via IrDA connector (refer to section 2.3 "Connectors").
setting allows infrared serial communication at a maximum baud rate of
115K baud.
•
-
ASKIR
connector (refer to section 2.3 "Connectors"). This setting allows infrared
serial communication at a maximum baud rate of 19.2K baud.
Integrated Peripherals
Onboard Parallel
Port
3BC/IRQ7
378/IRQ7
278/IRQ5
Disabled
3-34
UART Mode Select
This item is configurable only if the "Onboard UART
2" is enabled. This allows you to specify the mode
of serial port2. The available mode selections are:
-
Sets serial port 2 to operate in normal mode. This is the
Select this setting if you installed an Infrared module in your
Select this setting if you installed an Infrared module via IrDA
Onboard Parallel Port
This item controls the onboard parallel port address
and interrupt.
Note: If you are using an I/O card with a parallel
port, make sure that the addresses and IRQ do not
conflict.
This