Jumper And Connector Locations; Hardware Installation - AOpen AX3L User Manual

Chapter

Hardware Installation

This chapter gives you a step-by-step procedure on how to install your system.
Follow each section accordingly.

2.1 Jumper and Connector Locations

The following figure shows the locations of the jumpers and connectors on the
system board:
2
Caution: Electrostatic discharge (ESD) can
damage your
expansion boards, and other components.
Always observe the following precautions
before you install a system component.
1. Do not remove a component from its
protective packaging until you are ready
to install it.
2. Wear a wrist ground strap and attach it to
a metal part of the system unit before
handling a component. If a wrist strap is
not available, maintain contact with the
system unit throughout any procedure
requiring ESD protection.
processor, disk drives,
2-1