Ide Hdd Auto Detection; Save And Exit Setup; Load Eeprom Default; Save Eeprom Default - AOpen AX3L User Manual

AWARD BIOS
To disable the password, press when prompted to enter the password. The
screen displays a message confirming that the password has been disabled.

3.11 IDE HDD Auto Detection

If your system has an IDE hard drive, you can use this function to detect its
parameters and enter them into the "Standard CMOS Setup" automatically.
This routine only detects one set of parameters for your IDE hard drive. Some
IDE drives can use more than one set of parameters. If your hard disk is
formatted using different parameters than those detected, you have to enter
the parameters manually. If the parameters listed do not match the ones used
to format the disk, the information on that disk will not be accessible. If the
auto-detected parameters displayed do not match those that used for your
N
drive, ignore them. Type to reject the values and enter the correct ones
manually from the Standard CMOS Setup screen.
3.12 Save & Exit Setup
This function automatically saves all CMOS values before leaving Setup.

3.13 Load EEPROM Default

Except "Load Setup Default" and "Load Turbo Default", you may also use
"Save EEPROM Default " to save your own settings into EEPROM, and reload
by using this item.

3.14 Save EEPROM Default

You may use this item to save your own settings into EEPROM. Then, if the
data in CMOS is lost or you forget the previous settings, you may use "Load
EEPROM Default " to reload.
3-36