Complete The Assembly - Vermont Castings UVS27R Owner's Manual

Vermont Castings UVS27
D
Left Ember Log
ST110
Fig. 14 Install left and right ember strips and lava rocks.
G
B
Fig. 15 Install the two top logs; engage pins on the middle
logs with the sockets of the top logs.

Complete the Assembly

Replace the screen frame or glass assembly and swing
the fastening cams inward to fasten the assembly in
place.
Grasp the Front Plate by the window bars and lift into
position engaging the two steel tabs behind the adja-
cent bosses in the Side Plates. (Fig. 16) Then seat the
Front against the sides so that the tabs at the bottom lip
engage with the notches in the stove legs.
On the Pinnacle, the Front tabs will engage behind the
notched cutouts in the base of either Side Plate. (Fig.
17)
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without lifting it.
NOTE: Be sure that the Control Door can swing out. It
should close against the steel tab stop.
If installing the optional warming shelf, you may find it
most easy to attach it to the Top Plate before placing
the Top in position on the stove. Follow the instructions
supplied with the kit.
12
E
Right
Ember
Log
Lava Rock
F
A
C
ST111
Tilt the Top Plate to engage its rear rib in front of the
Back Panel, then carefully lower it onto the sides. (Fig.
18) The upper edge of the side plates should seat into
the channel in the underside of the Top.
Lay the mesh and top grille in place.
This completes assembly of the Stardance Freestand-
ing and Pinnacle Hearthmount shells.
Engage steel tabs behind
the cast iron bosses.
Fig. 16 Install the Front Plate. Your Front may look different
from that depicted.
ST113
Fig. 17 Engage the Hearthmount Front with the notch in the
base of each side plate.
Levelling
Screws
Fig. 18 Install the Top Plate and Grille.
Control Door
Bottom Tabs engage
notch in the leg.
ST112
Bottom Tabs engage
notch in the base
Grille
Top Plate
ST114